I've been playing with Solidworks (mostly engines) for quite a while now and thought I'd post some pictures. After many years of dreaming, drawing and driving I've fallen in love with one car-configuration. So I want to try and model more parts of this. The basic concept is a midengined car. The engine is a 1.5-2.5 litre 120 degree V12 and a very short 6-speed gearbox. The car a about 3.5 meter long and about 0.95 m high. The cockpit is very cramped, maybe single seater. I am not very good at drawing car bodys so I was hoping maybe someone could help. I want the body to look very agile. There should also be lots of curves. The body shall curve to the floor, no sharp skirts, splitters etc. Basically the body should not be aerodynamic like old classics I will post som pictures of some shapes I've made and see what you think. I've shown these to people before and they confirmed it looked bad so I need some help