3300 lg7 in a 1994 Chevrolet Beretta
I moved the post it seemed like a good idea.

I wanted to put a 3300 lg7 (from a 1989 Oldsmobile Cutlass Ciera) in a 1994 Chevrolet Beretta that came with a 2.2L (heard its been done before)

any thoughts on this engine the 3.3?
3300 (LG7) A smaller 3.3 L 3300 was introduced in 1989 and produced through 1993. It is effectively a lower-deck version of the 3800, with a smaller 3.7 in (93.98 mm) bore and 3.16 in (80.26 mm) stroke for 3,340 cc (204 cu in).[3] Like the 3800, it used a cast iron block and heads, push rods, and hydraulic lifters. Unlike the 3800, however, it used a batch-fire injection system rather than sequential injection, as evidenced by the lack of a cam position sensor. It also did not have a balance shaft. Power output was 160 hp (119 kW) at 5,200 rpm and 185 lbft (251 Nm) at 2,000 rpm with a 5,500 rpm redline.

I haven't been able to find much but what i have heard has all been glowing reviews. but ti didn't have a long production period (4 years)

any thoughts on the swap it's self or the Beretta? All ideas are vary appreciated

Here is the info I've been looking at
http://minneapolis.craigslist.org/cs...847720570.html
http://www.digplanet.com/wiki/Buick_V6_engine#3300
http://www.automobile-catalog.com/make/chevrolet_usa/beretta/beretta/1994.html

Thank you for your time!